Acta Metallurgica Sinica (English Letters) >
Crystal defects formed in electroformed nickel liners of shaped charges
Two types of electroformed nickel liners of shaped charges were prepared by electroforming technique. X-ray diffraction (XRD), transmission electron microscopy (TEM), electron backscattering diffraction (EBSD) technique and high resolution electron microscopy (HREM) have been employed to investigate the crystal defects formed in electroformed nickel liners of shaped charges. The result shows that (100) fiber texture which is parallel to the grown direction exists in the electroformed nickel prepared by using direct current electroforming without any additives, and (111) fiber texture exists in the electroformed nickel prepared by using direct current electroforming with additives. The deposits prepared by using direct current electroforming possess columnar grain with an average grain size of 30 μm in width and 170 μm in length. The deposits prepared with additives are composed of a colony structures with grain size of about 29 nm, and a lot of crystal defects such as twins, antiphase boundaries and stacking faults have been observed in the electroformed nickel.
Key words： Electroformation; Nickel; Nanostructure; Crystal defect; Texture
Feng Yang , Wenhuai Tian , Chuanchao Feng , Baosheng Wang . Crystal defects formed in electroformed nickel liners of shaped charges[J]. Acta Metallurgica Sinica (English Letters), 2009 , 22(5) : 383 -391 . DOI: 10.1016/S1006-7191(08)60112-X
[1] T. Wang, L. Wang, W. Ruan and T. Zhao, Chin J High Pressure Phy 10 (1996) 291.
[2] W.H. Tian, S.L. Hu, A.L. Fan and Z.R. Wang, Radiat Eff Defects in Solids 157 (2002) 145.
[3] M.L. Duffy and S.K. Golaski, Technical Report BRL-TR-2800, US Army Ballistic Research Laboratory, Aberdeen Proving Ground, MD (1987).
[4] W.H. Tian, A.L. Fan, H.Y. Gao, J. Luo and Z. Wang, Mater Sci Eng A350 (2003) 160.
[5] A.L. Fan, Sh.K. Li and W.H. Tian, Mater Sci Eng A474 (2008) 208.
[6] N. Wang, PhD Thesis, University of Toronto, Canada,1997.
[7] A.D. Jensen Jens, O.Å. Persson Per, P. Karen, M.Oden, H. Lars and A.J. Somers Marcel, Surf Coat Technol 172 (2003) 79.
[8] U. Klementl, U. Erb and K.T. Aust, Nanostruct Mater 6 (1995) 581.
[9] F. Dalla Torre, P. Spatig, R. Schaublin and M.Victoria, Acta Mater 53 (2005) 2337.
[10] K. Shigeaki and K. Youhei, Mater Sci Eng A 358 (2003) 76.
[11] Y. Xiong and T.F. Jing, Plat Finish 22 (2000)1.
[12] N. Wang, Z.R. Wang, K.T. Aust and U. Erb, Acta Metall Mater 45 (1997) 1655.
[13] K.S. Kumar, S. Suresh, M.F. Chisholm, J.A. Horton and P.Wang, Acta Mater 51 (2003) 387.
[14] Q.F. Wang, P.C. Zhang, X.H. Wang, D.P. Ren, D.M. Lang and Y.Z. Zhang, Surface Surf Technol 33 (2004) 18.
[15] P. Scherrer and Nachr. Ges. Wiss. Gottingen, Math Phys kl 2 (1918) 98.
[16] A. Bastos, S. Zaefferer, D. Raabe and C. Schuh, Acta Mater 54 (2006) 2451.
[17] A.M. El-Sherik and U. Erb, J Mater Sci 30 (1995) 5743.
[18] V.M. Kozlov and L. Peraldo Bicelli, Mater Chem Phys 77 (2002) 289.
[19] T.E. Buchheit, D.A. LaVan, J.R. Michael, T.R Christenson and S.D. Leith, Metall Mater Trans A 33 (2002) 539.
[20] S.V. Prasad, J.R. Michael and T.R Christenson, Scr Mater 48 (2003) 255.
[21] F. Czerwinski and J.A. Szpunar, Nanostruct Mater 11 (1999) 669.
[22] L. Lu, Y.F. Shen, X.H. Chen, L.H. Qian and K. Lu, Science 304 (2004) 422.
[23] S. Nakahara, Acta Metall 36 (1988) 1669.
/
| 〈 |
|
〉 |
WeChat