Reduction of Low-grade Manganese Dioxide Ore Pellets by Biomass Wheat Stalk

  • Honglei ZHANG ,
  • Guocai ZHU ,
  • Hong YAN ,
  • Yuna ZHAO ,
  • Tiancheng LI ,
  • Xiujuan FENG
Expand
  • 1) College of Life Science and Bio-engineering, Beijing University of Technology, Beijing 100124, China
    2) Institute of Nuclear and New Energy Technology, Tsinghua University, Beijing 102201, China

Received date: 2012-12-10

  Revised date: 2012-01-13

  Online published: 2013-03-14

Supported by

National NaturalScienceFoundation ofChina(No. 50874067)

Abstract

An investigation on reducing low-grade manganese dioxide ore pellets was carried out by using wheat stalk as reductant. The main impact factors of reduction percent such as particle size, biomass/ore ratio, heating rate, nitrogen flow rate, temperature and time in reduction process were discussed. The morphology and component of manganese dioxide ore particle at different stages were also analyzed by scanning electron microscopy (SEM) and energy dispersive X-ray spectroscopy (EDS). The results show the increase of the reduction temperature and time, biomass/ore ratio, and the decrease of particle size, heating rate and nitrogen flow rate can significantly enhance reduction efficiency. The reduction kinetic of the manganese ore is controlled by three-dimensional mass diffusion of gaseous reductive volatiles passing from the surface to the core of the ore particles. The activation energy E and frequency factor A were calculated to be 24.15 kJ·mol-1 and 166 min-1, respectively. Biomass pyrolysis volatiles adsorbed onto the surface of the ore particle leads to serious variation of the microstructures and chemical composition of the manganese ore particles.

Cite this article

Honglei ZHANG , Guocai ZHU , Hong YAN , Yuna ZHAO , Tiancheng LI , Xiujuan FENG . Reduction of Low-grade Manganese Dioxide Ore Pellets by Biomass Wheat Stalk[J]. Acta Metallurgica Sinica (English Letters), 2013 , 26(2) : 167 -172 . DOI: 10.1007/s40195-012-0250-x

References

[1] J. Yang and Z.M. Zeng, China Manganese Ind. 29 (2) (2011)6(in Chinese).


[2] N. Duan, Z.G. Dan and D.N. Song, J. Environ. Eng. Technol. 1 (1)(2011)75(in Chinese).

[3] D.W. Hu and D.D. Feng, China Mining Mag. 20 (6) (2011)1(in Chinese).

[4] K.S.A. Halim, M. Bahgat, M.B. Morsi and K. El-Barawy, Ironmaking Steelmaking 38 (4)(2011)279.

[5] A.A. Ismail, E.A. Ali, I.A. Ibrahim and M.S. Ahmed, Can. J. Chem. Eng. 82 (2004)1296.

[6] C. Abbruzzese, Hydrometallurgy 25 (1990)85.

[7] T.A. Lasheen, M.N. El Hazek and A.S. Helal, Hy­drometallurgy 98(2009)314.

[8] G. Senanayake, Hydrometallurgy 73 (2004)215.

[9] R.N.Sahoo,P.K.NaikandS.C.Das,Hydrometallurgy 62 (2001)157.

[10] S. Acharya, Metall. Trans. B 22 (1991)259.

[11] M.S.Bafghi,A.Zakeri,Z.GhasemiandM.Adeli,Hy­drometallurgy 90 (2008)207.

[12] I. De Michelis, F. Ferella, F. Beolchini and F. Vegli`o, Waste. Manage. 29 (2009)128.

[13] D. Hariprasad, B. Dash, M.K. Ghosh and S. Anand, Miner. Eng. 20 (2007)1293.

[14] Z. Cheng, G.C. Zhu and Y.N. Zhao, Hydrometallurgy 96 (2009)176.

[15] J.J. Song, G.C. Zhu, P. Zhang and Y.N. Zhao, Acta. Metall. Sin. (Engl. Lett.) 23 (2010)223.

[16] Y.N. Zhao, G.C. Zhu and Z. Cheng, Hydrometallurgy 105 (2010)96.

[17] F.W.Y.Momade andZ.G.Momade,Hydrometallurgy 54 (1999)25.

[18] F. Alenazey, C.G. Cooper, C.B. Dave, S.S.E.H. El­nashaie, A.A. Susu and A.A. Adesina, Catal. Com­mun. 10 (2009)406.
Outlines

/